Motorola VC6000 Series Product Reference Manual page 35

50 Pin Accessory Cable
The 50 Pin Accessory Cable serves as an adaptor cable betwwen the 9 Pin Deutsch Telemetry Cable (P.N
3089906Y63) or 6 Pin Deutsch Telemetry Cable (P.N 3089906Y63) and the VC6000 Series.
Connect the cable into the Auxiliary port of the VC6000 Series (see
1.
screws.
Connect J2, J3 and J4 connectors to the telemetry receptacles of your vehicle data bus.
2.
Connect the I/O wires as required (see
3.
J1 To VC6000 Series Auxiliary Port
I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog inputs, Debug (2 wires for debugging). See label on wires. Maximum
current through wires 0.5 A
50 Pin Accessory Cable
Figure 2-8
Auxiliary Port Pin layout
For connecting the I/O wires, use the I/O wires lables and the Auxiliary connector pinout detailed in
below.
Auxiliary Connector Pinout Details
Table 2-2
Pin # Name
1 RD_OUT1
3 RD_OUT2
5 RD_OUT3
7 RD_OUT4
9 RD_OUT5
11 RD_OUT6
15 RD_OUT8
Table 2-2).
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
Installation
Figure 2-8). Fasten the connector's
J2 RS232 (D-type -
Male) Connector
J3 RS232 (D-type -
Male) Connector
J4 RS232 (D-type -
Female) Connector
Functionality
2 - 7
Table 2-2