Mounting The Combination Antenna (Vc6096 Only) - Motorola VC6000 Series Product Reference Manual

2 - 10 VC6000 Series Product Reference Guide

Mounting the Combination Antenna (VC6096 only)

The Combination Antenna is an optional omni-directional WWAN and WLAN antenna used with the VC6096. The
antenna mounts inside/outside the vehicle cabin or indoors/outdoors (see
Combination Antenna - Vehicle Mount
Figure 2-9
The antenna has two external RF connectors that connect to the VC6096 via two low loss RF coax cables
CAUTION
To install the Combination Antenna (see
Connect the WWAN and WLAN Cable
1.
Connectors.
Place the Lower Cables Bracket under the
2.
cables so that the two holes align with the
screw inserts on the antenna.
Place the Upper Cables Bracket on top of the
3.
WWAN and WLAN Cable Connectors.
Align the two holes on the Upper and Lower
4.
Cables Brackets with the screw inserts and
secure the two M4 Screws (Torque 5 in-lbs).
Use the three (x3) Antenna Bracket Inserts to
5.
mount the antenna. Secure the antenna using
three M4 screws.
To avoid damage to the VC6096, make sure to disconnect the power cable from the VC6096 before
connecting the antenna cable. When installing the antenna cable, make sure to connect the antenna
side of the cable before connecting to the VC6096.
Figure
or
Vehicle Windshield
2-10):
WWAN Cable Connector (Keep covered when not in use).
Combination Antenna - Installation Guidelines
Figure 2-10
Figure 2-10).
Antenna Bracket Inserts (x3)
Screw Inserts (x2)
Upper Cables Bracket
M4 Screws (x2)
WLAN Cable Connector
(Keep covered when not in use).
Lower Cables Bracket