Motorola VC6000 Series Product Reference Manual page 33

9 Pin Deutsch Cable
Connect J1 connector into the Auxiliary port of the VC6000 Series (see
1.
screws.
Connect J2 - J3 plugs to the telemetry receptacles of your vehicle data bus.
2.
Connect the I/O Wires as required (see
3.
J1 to VC6000 Series Auxiliary Port
I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog inputs, Debug (2 wires for debugging). See label on wires. Maximum
current through wires 0.5 A
9 Pin Deutsch Cable
Figure 2-4
6 Pin Deutsch Cable
Connect J1 connector into the Auxiliary port of the VC6000 Series (see
1.
screws.
Connect J2 - J3 plugs to the telemetry receptacles of your vehicle data bus.
2.
Connect the I/O Wires as required (see
3.
J1 to VC6000 Series Auxiliary Port
I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog inputs, Debug (2 wires for debugging). See label on wires. Maximum
current through wires 0.5 A
6 Pin Deutsch Cable
Figure 2-5
Table 2-2).
Table 2-2).
Installation
Figure 2-4). Fasten the connector's
J2 RS232 (D-type -
Male) Connector
J3 Deutsch 9 Pin
Telemetry Connector
(HD17-9-1939s)
Figure 2-5). Fasten the connector's
J2 RS232 (D-type -
Male) Connector
J3 Deutsch 6 Pin
Telemetry Connector
(HD16-6-12s)
2 - 5