End Gear; Removing The Hub Cover; Removing The Wheel Axle; Removing The Wheel Axle Bearings - Gilera Runner RST 50 SP Service Station Manual

Runner RST 50 SP
Locking torques (N*m)
Driving pulley nut
40÷ 44*

End gear

Removing the hub cover

• Remove the transmission cover
• Remove the clutch assembly
• Discharge the rear hub oil.
• Remove the 5 screws indicated in the figure.
• Remove the hub cover with driven pulley shaft.
See also
Refitting the clutch

Removing the wheel axle

- Remove the intermediate gear and the complete
gear wheel axle.
- When removing the intermediate gear pay atten-
tion to the various shim adjustments.

Removing the wheel axle bearings

- Remove the oil seal and the seeger ring.
- Remove the bearing by pushing from the outside
towards the inside of the gear compartment, using
the appropriate punch.
Specific tooling
020363Y 20 mm guide
020376Y Adaptor handle
020358Y 37x40-mm adaptor
Engine
ENG - 77