Checking The Spark Advance - Gilera Runner RST 50 SP Service Station Manual

Runner RST 50 SP
Safety locks - check
Suspensions - check
Electrical system and battery - check
Headlight - adjustment
Tyre pressure and wear - check
SAS box (sponge) (**) - cleaning
Vehicle and brake test - road test
(**) See the regulations of the "Secondary air system" section
160'
Hub oil - change
Spark plug/electrode gap - replacement
Air filter - clean
Idling speed (*) - adjustment
Oil mixer/throttle linkage - adjustment
Driving belt - replacement
Variable speed rollers - replacement
Mixer belt - replacement
Coolant level - check
Radiator - external cleaning/ check
Odometer gear - greasing
Steering - adjustment
Brake control levers - greasing
Brake pads - check condition and wear
Flexible brake tubes - replacement
Brake fluid level - check
Transmission elements - lubrication
Safety locks - check
Suspensions - check
Electrical system and battery - check
Headlight - adjustment
Tyre pressure and wear - check
SAS box (sponge) (**) - cleaning
Vehicle and brake test - road test
(**) See the regulations of the "Secondary air system" section

Checking the spark advance

-Check to made at a regime over 4000 rpm with
stroboscopic gun. The advance measured must
be 16° before the dead centre position.
- Before checking, remove the rubber cap shown
in the figure; this makes it possible to view a fixed
reference on the flywheel cover
N.B.
IN CASE OF MALFUNCTION, CARRY OUT THE CHECKS
PROVIDED FOR IN THE ELECTRICAL SYSTEM CHAPTER.
CAUTION
BEFORE CARRYING OUT THE ABOVE CHECKS, CHECK
THE CORRECT KEYING OF THE FLYWHEEL ON THE
CRANKSHAFT.
Specific tooling
020330Y Stroboscopic light to check timing
Action
AT 60000 KM
Action
Maintenance
MAIN - 29