Fitting And Caulking The Kickstand Pin To The Bracket; Replace Complete Kickstand - Gilera Runner RST 50 SP Service Station Manual

Suspensions
- Remove the stand support bracket from the en-
gine.
- Drill a 5 mm hole in the bracket so that the pin
«P» can come out.

Fitting and caulking the kickstand pin to the bracket

- Caulk the end of the pin «P» between the two
punches shown in the figure.
- After caulking it must be possible for the stand to
turn freely.
N.B.
UPON REFITTING USE NEW O-RING AND PIN, GREASE
THE SPRING ATTACHMENTS AND THE PIN.

Replace complete kickstand

- Work on the screws shown in the figure.
- When refitting, secure to the prescribed torque.
Locking torques (N*m)
Stand screw torque
18.5 to 19 Nm
SUSP - 108
Runner RST 50 SP