Checks And Inspections - Gilera Runner RST 50 SP Service Station Manual

Electrical system
4 Grounding for phonic wheel
5 Power supply to phonic wheel
6
7 Instrument light and parking light indicator
8 Instrument temperature mass
9
10
11 Instrument temperature signal
12
13
14 + Right direction indicator
15
16
17
18
19
20

Checks and inspections

Checks to be made in the case of ignition irregularities and/or no spark on the spark plug
1. Check the condition of the spark plug (clean it with a metal brush, remove the encrustations, blast
it with compressed air and, if necessary, replace it).
2. Without removing the stator, carry out the following checks:
After visually checking the electrical wiring, perform measurements on the loading reel, the pickup (see
chart) and the continuity using the appropriate tester.
If checks on the loading reel, pickup and continuity show abnormalities, replace the stator; otherwise
replace the central unit. Remember that disconnections due to replacement of the central unit must be
done with the engine off.
Specific tooling
020331Y Digital multimeter
1
1 Yellow and red-blue cable
ELE SYS - 52
Specification
Phonic wheel signal
Not connected
Rpm indicator signal
Fuel level sensor
High-beam warning light
+ Left direction indicator
Low-oil warning light
Low fuel warning light
Not connected
Not connected
Not connected
CHECK ON THE PICK UP
Specification
Red and white cable
CHECK ON THE RELOAD REEL
Specification
Runner RST 50 SP
Desc./Quantity
Desc./Quantity
90±140 ohm
Desc./Quantity
800±1100 ohm