Establishing Ethernet Connection; Led Indicators (Crd5501-4000Er); Four Slot Battery Charger; Charging Spare Batteries - Motorola MC67 User Manual

110 | Accessories

Establishing Ethernet Connection

Note: Refer to the MC67 Integrator Guide for information on configuring the Ethernet settings.
Procedure:
1 Touch
.
2
Touch .
3 Touch Ethernet.
4 Slide the Ethernet switch to the ON position.
5 Insert the MC67 into a slot.

Figure 75: MC67 Battery Charging

The icon appears in the Status bar.
6 Touch Eth0 to view Ethernet connection details.

LED Indicators (CRD5501-4000ER)

There are two green LEDs on the front of the cradle. These green LEDs light and blink to indicate the data transfer
rate. When the LEDs are not lit the transfer rate is 10 Mbps.

Table 12: CRD5501-4000ER LED Data Rate Indicators

Data Rate
1 Gbps
100 Mbps
10 Mbps

Four Slot Battery Charger

This section describes how to use the Four Slot Battery Charger to charge up to four MC67 batteries.

Charging Spare Batteries

Procedure:
1 Connect the charger to a power source.
2 Insert the battery into a battery charging well and gently press down on the battery to ensure proper contact.
Send Feedback | January 2014 | MN000115A01
Left LED (Green)
On/Blink
Off
Off
Right LED (Green)
Off
On/Blink
Off