Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Motorola DS4208 Product Reference Manual

4 - 2 DS4208 Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change the default values, scan the appropriate bar
codes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan the
NOTE See
miscellaneous default parameters.
Table 4-1
User Preferences Parameter Defaults
Parameter
User Preferences
Set Default Parameter
Parameter Bar Code Scanning
Beep After Good Decode
Beeper Tone
Beeper Volume
Beeper Duration
Suppress Power-up Beeps
Low Power Mode
Time Delay to Low Power Mode
Hand-Held Trigger Mode
Picklist Mode
Continuous Bar Code Read
Unique Bar Code Reporting
Set Default Parameter on page
Appendix A, Standard Default Parameters
Parameter
Number
ECh
38h
91h
8Ch
F1h 74h
F1h D1h
80h
92h
8Ah
F0h 92h
F1h 89h
F1h D31h
Beeper Tone on page 4-6. The digital scanner issues a
4-4.
for all user preferences, hosts, symbologies, and
Default
Set Defaults
Enable
Enable
Medium
High
Medium
Do not suppress
Disable
1 Hour
Auto Aim
Always Disabled
Disable
Disable
Page
Number
4-4
4-5
4-5
4-6
4-7
4-8
4-8
4-9
4-9
4-12
4-13
4-14
4-14