Multicode Expression; Multicode Expression Syntax: [N] [Element 1]; [Element 2 ] - Motorola DS4208 Product Reference Manual

4 - 24 DS4208 Digital Scanner Product Reference Guide

Multicode Expression

Parameter # F1h 95h
Use this feature to program a multicode expression for
indicates any bar code.
To set the multicode expression:
Scan the bar code below.
1.
Scan bar codes from the alphanumeric keyboard in the Advanced Data Formatting Programmer Guide to
2.
define the expression.
Scan the
3. End of Message
Multicode Expression
Multicode Expression Syntax: [n] [Element 1]; [Element 2 ]; ... [Element n];
Where n is the number of elements in the overall expression.
The multicode expression describes the bar code(s) that the digital scanner can expect to find in an image. Each
element represents one bar code in the digital scanner's field of view. The order of elements in the expression is
the order in which bar code data from each element transmits to the host. Elements are defined using one or more
of the following methods:
. This type of element limits decoding to a specific area within the digital scanner's field of view. Region
By Region
coordinates are defined as the top left and bottom right corners of the region, expressed in percentages of the field
of view. These can range from 0% to 100%, or 0x00 to 0x64 in hex, for both horizontal and vertical axes. A region
element is constructed as:
[R] [4] [Top, Left] [Bottom, Right]
Where:
•
[R] is the character R
•
[4] is 0x04, indicating there are four bytes thereafter to describe the region
•
[Top, Left] are two values representing the top left corner of the region
•
[Bottom, Right] are two values representing the bottom right corner of the region
. An element can specify a specific bar code symbology to find and decode somewhere in the field of
By Code Type
view. A code type element is constructed as:
[C] [2] [Code Type]
Where:
•
[C] is the character C
•
[2] is 0x02, indicating there are two bytes thereafter to describe the code type
•
[Code Type] is the desired symbology's parameter number (see
parameter numbers, extend the value to two bytes by adding 00 before the parameter number.
Multicode Mode
bar code from the Advanced Data Formatting Programmer Guide.
(grid method). The default is 1, which
Chapter 9, Symbologies). For single-byte