Setting Up the Digital Scanner
Installing the Interface Cable
Insert the interface cable modular connector into the interface cable port on the rear of the digital scanner until
1.
an audible click sounds. Low/medium/high beeps sound, indicating the scanner is operational.
Cable interface
port
Interface cable
modular connector
Figure 1-2
Installing the Cable
IMPORTANT Insert the cable into the cable interface port until an audible click sounds.
Gently tug the cable to ensure the connector is secure.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
3.
connections).
Interface cable modular
connector clip
To host
When connecting the DS4208 using a USB cable, a shielded connector cable is required (e.g., p/n
CBA-U21-S07ZAR). If upgrading an LS2208 or LS4208 to a DS4208, use the shielded connector
cable.
Getting Started
1 - 3