Table of Contents
Advertisement
HOME
b0636x7x
Continues to Main
Connector [10]
Electronic Control
6.
See
Figure 1-49.
Set static timing. This will align open-
ings (1, 2) on trigger cup with cam position sensor.
a.
Set engine stop switch to RUN.
b.
Turn ignition switch to IGN.
c.
See
Figure 1-46.
Loosen two screws (5) on cam
position sensor (7). Rotate sensor clockwise until
the voltmeter registers the change from 0.0-1.0 VDC
to 5.0 VDC (+/- 0.5 volts).
d.
Tighten both sensor screws (5) to 10-20 in-lbs (14-
27 Nm).
7.
Install inner cover (4), inner cover screws (3), outer cover
(2) and new outer cover rivets (1).
8.
Install spark plugs, shift transmission into neutral and
remove jack.
9.
Remove BREAKOUT BOX harness and connect elec-
tronic control module connector [11].
11
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
10. Install seat. See
2.40 SEAT.
1-38
Wiring Harness
Connector [11]
Module
Figure 1-48. Static Timing Connections
WARNING
1
2
3
4
5
6
7
8
9
10
Black
11
12
1
2
3
4
5
6
7
8
9
10
(+) Lead to Gray 3
(-) Lead to Gray 8
Gray
11
12
6889
1
1.
Large Opening
2.
Small Opening
3.
Front Cylinder Top Dead Center Window
Figure 1-49. Trigger Cup Openings
(Cam Position Sensor Removed For Illustration)
VDC
3
2
2002 Buell X1: Maintenance
Advertisement
Chapters
Table of Contents
Troubleshooting
