Horn - Buell 2002 X1 Handbook

HOME

HORN

REMOVAL
1. Remove seat. See 2.40 SEAT.
1 1
WARNING WARNING
The gasoline in the fuel supply line downstream of the
fuel pump is under high pressure (49 psi [338 kPa]). To
avoid an uncontrolled discharge or spray of gasoline,
always purge the system of high pressure gas before
attaching fuel pressure gauge. Gasoline is extremely
flammable and highly explosive. Inadequate safety pre-
cautions could result in death or serious injury.
2. Purge fuel line and remove fuel tank. See
TANK.
3. Remove air scoop. See
4. See Figure 7-68. Remove bolt (1) and washer (2).
5. Remove horn (3) from frame.
6. See Figure 7-69. Detach Y/BK power wire and BK
ground wire from terminal clips on back side of horn.
INSTALLATION
1. See Figure 7-69. Connect Y/BK power wire and BK
ground wire to terminal clips on back side of horn.
2. See Figure 7-68. Attach horn (3) to frame using bolt (1)
and washer (2).
3. Check horn operation. If horn does not sound or fails to
function satisfactorily, see TROUBLESHOOTING.
a. Turn ignition key switch to IGN.
b. Press horn switch to activate horn.
c. Turn ignition key switch to OFF.
4. Install air scoop. See 2.36 AIR
5. Install fuel tank. See 4.37 FUEL
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
6. Install seat. See 2.40 SEAT.
2002 Buell X1: Electrical
4.37 FUEL
2.36 AIR SCOOP.
SCOOP.
TANK.
6872
2
3
1. Bolt
2. Washer
3. Horn
Figure 7-68. Horn Assembly
b0624x7x
LOW BEAM
LIGHT POWER
HIGH BEAM
HORN
FROM FLASHER
LEFT TURN
RIGHT TURN
HORN POWER
Left Handlebar Switch
Figure 7-69. Horn Wiring
7.21
1
[24]
W Y
1
BE
BN 2
W
BK 3
GN 5 Y/BK
BE V/BN
6
V
O 7
L.BE BN
8
9
GY O/W
Horn
BK
Y/BK
7-51