Buell 2002 X1 Handbook page 356

HOME
3557
3
1
1. Retention Collar
2. TORX Screw
3. Detent Roller Arm
Figure 6-29. Countershaft Retainer
11. See Figure 6-29. Lock transmission in gear. Remove
countershaft TORX screw (2) and retention collar (1).
12. See Figure 6-30. Detach spring (1) from groove in
post (2).
13. Remove retaining ring (9) and detent plate (8). You will
need to use a new retaining ring for installation.
14. Remove two locknuts (3) and washers (10) which attach
shifter shaft assembly (6) to studs at transmission case.
Remove shifter shaft assembly.
15. Remove five access door bolts (7). Remove transmission
assembly by pulling it straight outward, away from trans-
mission case.
CLEANING AND INSPECTION
Thoroughly clean transmission compartment with cleaning
solvent. Blow parts dry with compressed air. Inspect parts to
determine if any must be replaced. Replace all parts that are
badly worn or damaged.
Neutral Indicator Switch
See Figure 6-31. The neutral indicator switch is threaded into
the transmission portion of the right crankcase half. See
NEUTRAL INDICATOR SWITCH
installation procedures.
6-20
2
7.22
for testing, removal and
b0153x6x
5
3 10
1
4
6
8
9
1. Spring
2. Post
3. Locknut (2)
4. Detent Screw
5. Pawl
6. Shifter Shaft Assembly
7. Bolt (5)
8. Detent Plate (Typical)
9. Retaining Ring
10. Washer (2)
Figure 6-30. Shifter Shaft Assembly
6753
Figure 6-31. Neutral Indicator Switch
2002 Buell X1: Drive/Transmission
7
2
7
Neutral Indicator
Switch