Buell 2002 X1 Handbook page 379

HOME
INSTALLATION
1. Install ignition key switch.
a. See Figure 7-2. From behind the dash panel, insert
ignition switch (1) into hole. The word "TOP"
stamped on the switch body should face upward
toward the lettering on the switch position decal.
b. Loosely install face nut (2).
2. See Figure 7-3. Attach ignition key switch connector to
main wiring harness.
3. See Figure 7-2. Tighten face nut to secure switch within
dash panel.
1 1
WARNING WARNING
Always connect the positive battery cable first. If the
positive cable should contact ground with the negative
cable installed, the resulting sparks may cause a battery
explosion which could result in death or serious injury.
4. Install battery cables, positive cable first.
1 1
WARNING WARNING
Check for proper headlamp operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper headlamp operation could
result in death or serious injury.
5. Check ignition key switch for proper operation. If opera-
tion fails, reread procedure and verify that all steps were
performed.
6. Install four screws and washers to attach windscreen to
mounting brackets.
7-6
Ignition Key Switch
Connector [33]
R
Ignition Key Switch
Figure 7-3. Ignition Key Switch Wiring
R /B K
IGN
R GY /
PARK
OFF
b0603x7x
2002 Buell X1: Electrical