Buell 2002 X1 Handbook page 124

HOME
TRUNK
REMOVAL
1. See Figure 2-128. Detach data link connector [91A] from
trunk.
2. See Figure 2-126. Remove two screws and washers (1)
and nuts and washers (2) securing front of trunk (4) to
tail section (5).
3. Remove two screws and washers (3) securing trunk (4)
to tail section (5) under edge of tail section.
4. See Figure 2-127. Remove screws and washers (1) from
indentation in license plate bracket (2).
5. Push down on center of trunk until trunk pops free of tail
section.
INSTALLATION
1. See Figure 2-126. Position trunk (4) in tail section (5).
2. Secure front of trunk (4) to tail section (5) with two
screws and washers (1) and washers and nuts (2).
3. Secure trunk (4) to tail section (5) with two screws and
washers (3) under edge of tail section.
4. See Figure 2-127. Secure trunk to license plate bracket
(2) with screws and washers (1).
5. See Figure 2-128. Attach data link connector [91A] to
trunk.
2002 Buell X1: Chassis
b0623x2x
3
6
5
4
7
1. Screw and Washer (2)
2. Washer and Nut (2)
3. Screw and Washer (2)
4. Trunk
5. Tail Section
6. Screw and Washer (2)
7. License Plate Bracket
Figure 2-126. Tail Section with Trunk
6885
License
Plate Bracket
Figure 2-127. License Plate Bracket
7987
Data
Link [91A]
Figure 2-128. Data Link Location
2.37
1
2
Screw and
Washer (2)
2-77