Buell 2002 X1 Handbook page 291

HOME
REMOVAL
1 1
WARNING WARNING
To protect against accidental start-up of vehicle, discon-
nect the negative battery cable before proceeding. Inade-
quate safety precautions could result in death or serious
injury.
1 1
WARNING WARNING
Always disconnect the negative battery cable first. If the
positive battery cable should contact ground with the
negative cable installed, the resulting sparks may cause
a battery explosion which could result in death or seri-
ous injury.
1. Disconnect both battery cables, negative cable first.
2. Remove left side scoop. See
3. See Figure 4-78. Disconnect the spark plug cables from
the coil plug posts (1, 2).
4. Detach connector (7) [83].
5. Remove two screws and washers to drop coil from
frame.
INSTALLATION
1. See Figure 4-77. Attach coil to frame with screws and
washers. Tighten to 4-6 ft-lbs (5-8 Nm).
2. See Figure 4-78. Attach connector (7) [83].
3. Connect front spark plug cable to connector (2) and rear
spark plug cable to connector (1).
4. Install left side scoop. See
1 1
WARNING WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
5. Connect battery cables, positive cable first.
2002 Buell X1: Fuel System
2.36 AIR SCOOP.
2.36 AIR SCOOP.
6587
Ignition Coil
Figure 4-77. Ignition Coil Location
6766
6
7
1. Rear Cylinder Post
2. Front Cylinder Post
3. Screw and Washer Location
4. Coil Pin A (rear cylinder)
5. Coil Pin B (12 VDC)
6. Coil Pin C (front cylinder)
7. Coil Connector [83]
Figure 4-78. Ignition Coil
4
3
5
2
1
4-95