Table of Contents
Advertisement
HOME
Ignition Relay
See
Figure 7-11.
The ignition relay is under the seat. Test the
relay as follows:
1.
See
Figure 7-12.
Remove seat and locate ignition relay
(1) within relay/diode block.
2.
Test the relay in the same fashion as the starter relay.
See Section 5.
3.
Replace the relay with a new relay if necessary.
Starter Relay
The starter relay (2) is under the seat. See
SYSTEM
DIAGNOSIS.
Ignition Fuse
See
Figure 7-11.
The ignition fuse (3) is in the fuse block
under the seat. Always replace the fuse with another 20
ampere fuse.
Diodes
1.
Remove seat and locate diodes within relay block (2).
2.
Test diodes using Starter Test flow charts under
NOSTICS.
3.
Identify the diode which must be replaced. Replace both
diodes if necessary.
4.
Replace the diodes by pulling them straight out. The
spare diode may be used in either circuit as long as it is
installed in the correct direction.
Main Circuit Breaker
Attached to the frame above the battery, the main circuit
breaker links the ignition key switch and the battery. See
FUSES AND CIRCUIT BREAKERS
7-14
5.3 STARTING
DIAG-
7.23
for more information.
6982
3
1
2
1.
Fuse Block
2.
Relay Block
3.
Ignition Fuse
Figure 7-11. Fuse and Relay Blocks
6763
1
6
1.
Ignition Relay
2.
Starter Relay
3.
Starter Circuit Diode
4.
Ignition Circuit Diode
5.
Spare Diode
6.
Mounting Tabs
Figure 7-12. Ignition Relay and Diodes
2
3
4
5
2002 Buell X1: Electrical
Advertisement
Chapters
Table of Contents
Troubleshooting
