Ejection To Stacker Tray - Dell 5130cn Service Manual

2.6 Ejection to Stacker Tray

When the processing as stapling or tamping is completed in the Compile Tray, the ROLLER ASSY
EJECT PINCH (PL 14.6.13) is lowered by the torque of the MOTOR ASSY EJECT (PL 14.5.6) and the
spring pressure of the SPRING PINCH (PL 14.6.2) to guide the sheet to the point between the
ROLLER EJECT PINCH (PL 14.6.16) and the ROLLER ASSY EJECT (PL 14.6.31).
Then, the sheet is ejected to the Stacker Tray by the ROLLER ASSY EJECT that rotates in the normal
direction driven by the MOTOR ASSY EJECT and controlled by the GEAR ASSY SECTOR (PL
14.5.18).
During the ejection to the Stacker Tray, the GUIDE PAPER 240 (PL 14.5.38) slides back to its original
position driven by the MOTOR ASSY EJECT so as not to obstruct the passage of the sheet.
Meanwhile, the CLUTCH Z34 (PL 14.5.25) transmits the torque of the MOTOR ASSY EJECT to the
SHAFT ASSY SET CLAMP (PL 14.6.32), retracting the Holder of the SHAFT ASSY SET CLAMP inside
the Finisher so as not to obstruct the passage of the sheet.
Upon completion of the sheet ejection, the Holder of the SHAFT ASSY SET CLAMP returns to its
original position to hold down the sheet ejected.
Stacker Tray
ROLLER ASSY
EJECT
SHAFT ASSY SET CLAMP
Finisher Service Manual
Version 1 2009.03.31
ROLLER EJECT PINCH
ROLLER ASSY EJECT PINCH
Paper
6 – 7
Chapter 6 Principles of Operation
SPRING PINCH
GUIDE PAPER 240
Tbt06106KA