Removal 2
KIT FINISHER ASSY (PL14.1.99)
In the following steps, the details of Step 1 are omitted because they are described earlier in this chap-
ter.
Go to the step in parentheses to execute the necessary steps, and then go to Step 2 onward.
1)
Remove the TRAY STACKER. (Removal 1)
2)-1
2)
Disengage the AC OUTLET of the CABLE ASSY POWER A4FIN (PL14.11.8) from the printer, and
then release the CABLE ASSY POWER A4FIN from the harness guide on the printer.
Continues to the next page.
Finisher Service Manual
Version 3 2009.07.03
Chapter 3 Removal and Replacement Procedures (RRPs)
2)-2
2)-2
3 - 8
Tbt03537KA