Dell 5130cn Service Manual page 28

Removal 4 KIT CHUTE ASSY LOWER H-TRA (PL14.2.98), KIT COVER ASSY TOP H-
TRA (PL14.2.99)
In the following steps, the details of Steps 1 through 3 are omitted because they are described earlier in
this chapter. Go to the steps in parentheses to execute the necessary steps, and then go to Step 4
onward.
1) Remove the TRAY STACKER. (Removal 1)
2) Remove the FINISHER ASSY. (Removal 2)
3) Remove the TRANSPORT ASSY A4. (Removal 3)
4)-2
4) Swing up the COVER ASSY TOP H-TRA (PL14.2.3) until the flat surfaces on the pivots of the
COVER ASSY TOP H-TRA becomes parallel with the U-shaped notches on the CHUTE ASSY
LOWER H-TRA (PL14.2.10).
5) Remove the COVER ASSY TOP H-TRA diagonally upward from the CHUTE ASSY LOWER H-
TRA.
Finisher Service Manual
Version 3 2009.07.03
5)
Chapter 3 Removal and Replacement Procedures (RRPs)
4)-1
3 - 14
Tbt03507KB