Dell 5130cn Service Manual page 34

Removal 7 HOLDER ASSY STAPLER A4 (PL14.8.19)
In the following steps, the details of Steps 1 through 3 are omitted because they are described earlier in
this chapter. Go to the steps in parentheses to execute the necessary steps, and then go to Step 4
onward.
1) Remove the TRAY STACKER. (Removal 1)
2) Remove the FINISHER ASSY. (Removal 2)
3) Remove the COVER ASSY FRONT. (Removal 5)
5)
4) Disengage the two sets of connectors (P/J8886, 8887) of the HOLDER ASSY STAPLER A4
(PL14.8.19).
When performing the following step, use caution not to drop the HOLDER ASSY STA-
PLER A4.
5) Remove the one screw (silver, flanged, 6mm) that fixes the HOLDER ASSY STAPLER A4 to the
FINISHER ASSY.
6) Loosen the one screw (silver, flanged, 6mm) that fixes the HOLDER ASSY STAPLER A4 to the
FINISHER ASSY.
7) Release the notch of the HOLDER ASSY STAPLER A4 from the loosened screws by slightly lifting
the HOLDER ASSY STAPLER A4. Then, remove the HOLDER ASSY STAPLER A4 from the FIN-
ISHER ASSY.
Finisher Service Manual
Version 3 2009.07.03
Chapter 3 Removal and Replacement Procedures (RRPs)
4)
3 - 20
6)
7)
Tbt03512KB