Device-Specific Commands - Stryker Sidne Operating And Maintenance Manual

status bar. The display bar will remain on the Device menu and
Sidne™ menu until the user says "Hide Status."
4. "Hide Status": Saying "Hide Status" will hide the status bar on
the Device menu or Sidne™ menu.
5. "Shaver Stop": Saying "Shaver Stop" issues a "Stop" command
to any shaver connected to the system.
• 1088 Digital Camera
• 988 Digital Camera
• 888 3-Chip Camera
• 688 1-Chip Camera
• SDC Pro
• SDC Pro2
• SDC HD
• X6000 Xenon Light
Source
• Q5000 Light Source
• TPS Arthroscopy
Shaver
*These drivers are available for purchase. Contact your local Stryker
Representative for ordering information.

Device-Specific Commands

The Sidne™ system is compatible with a wide variety of "Sidne™-smart"
operating-room devices, such as the devices listed below:
Each of these devices has its own set of voice and tablet commands, as
well as a unique set of audio feedback messages that come from the
Sidne™ console. Tablet-command menus and voice-command menus for
each device are listed in the following pages.
Note Should the Sidne™ system list a device as "unknown," a
device driver may need to be loaded onto the Sidne™
console to enable compatibility. Contact a Stryker
representative to determine compatibility with the Sidne™
system and to acquire a device driver. To load the device
driver onto the Sidne™ system, insert the device-driver
dongle into the device-driver dongle port on the front
console panel and follow the instructions spoken by
Sidne™. Please refer to the user addendum for the
specific device for more information.
32 EN
• 40L High Flow
Insufflator
• 30L High Flow
Insufflator
• 2.0L Arthroscopy Pump
• Toshiba Mega-Hi Printer
• Sony MD51 Printer
• Sony UP5600 Printer
• Sony 9500 VCR
• Sony 2100 VCR
• Telephone*
• FloControl Pump
• Valley Lab ESU*