Selecting The Video Source - Stryker Sidne Operating And Maintenance Manual

2. Position the headset over the head so the mouthpiece rests three
finger's breadth from the corner of the mouth.
3. Clip any excess cords to the back of the surgical gown.
Note Repeat the steps listed under "Setting Up the Headset" if a
second headset will be connected to the Sidne™ console.

Selecting the Video Source

In order to display the camera image properly, Sidne™ must know where
the camera has been connected. Use the tablet or microphone headset to
tell Sidne™ which video input port the camera is connected to. (For more
information on navigating tablet and voice-command menus, see the
Operating the Sidne™ System and Sidne™ Options sections in this
manual.)
1. To select the video source by using the tablet,
• Press the Options icon on the tablet screen.
• Press the icon that corresponds with the video source (input
port) the camera is connected to.
2. To select the video source by using the microphone headset,
• Say "Sidne™."
• Say "Options" (after Options has appeared on the monitor).
• Say "Source" (after Source has appeared on the monitor).
• Say the name of the video input port the camera is connected
to (after it has appeared on the monitor).
26 EN