User Manual of DS-7100NI Series NVR
NTP software can be used to establish a NTP server used for time synchronization.
9.2.4 Configuring Remote Alarm Host
Purpose:
With a remote alarm host configured, the NVR will send the alarm event or exception message to the host when an
alarm is triggered. The remote alarm host must have the Network Video Surveillance software installed.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 13.
3. Enter Alarm Host IP and Alarm Host Port in the text fields.
The Alarm Host IP refers to the IP address of the remote PC on which the Network Video Surveillance
Software (e.g., iVMS-4200) is installed, and the Alarm Host Port must be the same as the alarm
monitoring port configured in the software.
4. Click Apply button to save and exit the interface.
9.2.5 Configuring Multicast
Purpose:
The multicast can be configured to realize live view for more than 64 cameras through network for DS-7100NI-SL
series NVR.
A multicast address spans the Class-D IP range of 224.0.0.0 to239.255.255.255. It is recommended to use the IP
address ranging from 239.252.0.0 to 239.255.255.255.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 13.
3. Set Multicast IP, as shown in Figure 9. 15. When adding a device to the Network Video Surveillance
Software, the multicast address must be the same as the NVR's multicast IP.
Figure 9. 13 More Settings Interface
Figure 9. 14 Configure Alarm Host
102