Configuring Remote Alarm Host; Configuring Multicast - HIKVISION DS-8600 User Manual

User Manual of DS-9600/8600/7700/7600 Series NVR
4. Configure the following SNMP settings:
•
Trap Address: IP Address of SNMP host.
•
Trap Port: Port of SNMP host.
5. Click
Note: Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and
exception message to the surveillance center.

9.2.5 Configuring Remote Alarm Host

Purpose:
With a remote alarm host configured, the NVR will send the alarm event or exception message to the host when an
alarm is triggered. The remote alarm host must have the Network Video Surveillance software installed.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 15.
3. Enter Alarm Host IP and Alarm Host Port in the text fields.
The Alarm Host IP refers to the IP address of the remote PC on which the Network Video Surveillance
Software (e.g., iVMS-4200) is installed, and the Alarm Host Port must be the same as the alarm
monitoring port configured in the software.
4. Click

9.2.6 Configuring Multicast

Purpose:
The multicast can be configured to realize live view for more than 128 cameras through network for
DS-9600NI-ST/RT/XT series NVR. And for DS-8600/7700/7600NI-ST NVR, using the multicast function, more
than 64 cameras are connectable.
to save and exit the interface.
Figure 9. 15 More Settings Interface
Figure 9. 16 Configure Alarm Host
to save and exit the interface.
143