Electrical Wiring In The Burner Head; Removing Baffle Plate - Webasto Thermo Top Pro 120 Workshop Manual

Fig. 31 Removing control unit
A Control unit
B Bolt T20
Follow these steps:
1. Pull connector (C) out of control unit (A).
2. Remove screws of control unit (B) 4x14 T20 (4x).
3. Turn control unit toward front.
4. Pull connector at back out of control unit.
5. Remove control unit.
8.7

Electrical wiring in the burner head

NOTE
Electrical wiring must not lie against the blower fan
wheel.
Fig. 32 Electrical wiring
NOTE
There must be no electrical wiring in the specified area
(X).
After every removal of electrical wiring:
Carefully fit clip and cable tie, see the figures below.
9039412C Workshop manual TTP 120 _ 150
C Connectors
A
B
B
C
B
B
Fig. 33 Position of clip for electrical cables on housing
Fig. 34 Position of cable tie (on electrical wiring for ignition spark gen-
erator and nozzle block preheater)
8.8

Removing baffle plate

X
Fig. 35 Removing baffle plate
A Baffle plate
Repairing and replacing components | 8
B Fuel nozzle
A
B
31 / 49