Questions And Answers - Siemens Gigaset C380 User Manual

Questions and answers

If you have any questions about using
your phone, visit us at www.siemens.com/
gigasetcustomercare at any time.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The batteries are flat.
¥
Charge or replace the batteries
¢
( page 10).
Base
" " flashes in the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
The base station's range is reduced
because Eco Mode mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the hand-
set and base station.
3. The base station is not turned on.
¥
Check the base station's mains adapter
¢
( page 8).
Handset does not ring.
1. The ringer is deactivated.
¥
Activate the ringer (
You cannot hear a ringer/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
¢
( page 56).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000
¢
( page 47).
a
.
¢
page 41) or
¢
page 46).
Forgotten the system PIN.
¥
Reset the system PIN to 0000
¢
( page 47).
The other party cannot hear you.
You have pressed the
The handset is "muted".
¥
Activate the microphone again
¢
( page 24).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to release Calling Line Identification (CLI).
You hear an error tone (descending tone
sequence) when inputting.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the
network mailbox.
Your PABX is set for dial pulsing.
¥
Set your PABX to touch tone dialling.
Gigaset C385 only:
No time is specified for a message in the
answer machine history.
Date/time is not set.
¥
Set the date/time (
The answer machine announces "PIN is
incorrect" during remote operation.
1 You have entered the wrong system PIN.
¥
.
Enter the system PIN again.
2 The system PIN is still set to 0000.
¥
.
Change the system PIN (
The answer machine will not record any
messages.
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
Service Centre
§Mute§ display key.
¢
page 13).
¢
page 47).
51