Table of Contents
Advertisement
Appendix
Appendix
Care
Wipe the base station, charging cradle and
the handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.gigaset.com/cn
at any time. The table below contains a list
of common problems and possible solu-
tions.
The display is blank.
1. The handset is not turned on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge or replace the batteries
(page 5).
22
!
a
.
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key
"Base station x" flashes on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base sta-
tion.
2. The handset has been deregistered.
¥
Register the handset (page 6).
3. The base station is not turned on.
¥
Check the base station's mains adapter.
Base Search flashes in the display.
No base station turned on or in range.
¥
Move the handset closer to the base sta-
tion.
¥
Check the base station's mains adapter.
Handset does not ring.
The ringer tone is switched off.
¥
Activate the ringer tone (page 20).
The other party cannot hear you.
u
You have pressed the
set is "muted".
¥
Activate the microphone again (page 12).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to release Calling Line Identification (CLI).
You hear an error tone when keying an
input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your phone system is set for dial pulsing.
¥
Set your phone system to touch tone dial-
ling.
#
(page 8).
(INT) key. The hand-
Advertisement
Table of Contents
