Questions And Answers; Authorisation - Siemens Gigaset SL78H Manual

Customer Service & Assistance

Questions and answers

If you have any questions about using your
phone, visit us at
www.gigaset.com/customercare at any
time. The table below contains a list of com-
mon problems and possible solutions.
Registration or connection problems with
a Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
¥ guide for your headset).
Delete registration data from the handset
¥
when deregistering the device (
Repeat the registration process (
The display is blank.
¥
1. The handset is not switched on.
Press and hold the end call key
2. The battery is flat. ¥
¢
Charge the battery or replace it
( page 8).
No Base flashes in the display.
1. The handset is outside the range of the base. ¥
Move the handset closer to the base.
The range of the base is reduced because eco
mode is activated. ¥
Deactivate eco mode (
reduce the distance between the handset
and the base.
2. The base is not turned on. ¥
Check the base mains adapter.
Please register handset
"
play.
Handset has not yet been registered to the base
¥
or has been de-registered.
Register the handset (
Handset does not ring.
¥ The ring tone is deactivated.
Activate the ring tone (
The other party cannot hear you.
§Mute§
You have pressed the
The handset is "muted". ¥
Activate the microphone again (
48
¢
¢
page 40).
page 40).
a
.
¢
page 35) or
" flashes in the dis-
¢
page 10).
¢
page 44).
display key.
¢
page 26).
You will hear an error tone when inputting
(descending tone sequence).
¥ Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated
or deactivated. As a pixel is made up of
three sub-pixels (red, green, blue), it is
possible that pixel colours may vary.
This is completely normal and does not
indicate an error.

Authorisation

This device is intended for use within the
European Economic Area and Switzerland. If
used in other countries, it must first be
approved nationally in the country in ques-
tion.
Replacement or repair services are not
offered in countries where our product is not
sold by authorised dealers.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Con-
formity is available at this Internet address:
www.gigaset.com/docs
Certificate No
РОСС DE.MЛ05.B00821
valid till 26.10.2011.
Postal address of manufacturer:
Gigaset Communications GmbH,
Hofmannstrasse 61, 81379, Munich,
Germany.
ò
Bluetooth Qualified Design Identity
The Bluetooth QD ID for your Gigaset SL78H
is: B013322.