Table of Contents
Advertisement
First steps
Please note
u
Each key press interrupts the automatic registration.
u
If automatic registration does not work, the handset will have to be
registered manually (
To charge the batteries, leave the handset in the charging cradle.
Please note
Only place the handset in the base station or charging cradle that is
intended for it.
Should you have any questions and problems
Initial charging and discharging of batteries
The correct charge level can only be displayed if the batteries are first fully
charged and discharged.
Please note
u
After the first battery charge and discharge you may replace your hand-
set in its base station or charging cradle after every call.
u
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while, the charge capacity of the batteries will decrease for
technical reasons.
12
¢
page 42).
¤
Place the handset in the base station or
charging cradle for eleven hours.
11 h
¢
page 51.
¤
Then remove the handset
from the base station or
charging cradle and do not
replace it until the batteries
are completely discharged.
Advertisement
Table of Contents
