Questions And Answers; Authorisation - Siemens Gigaset SL78H Manual

Gigaset SL78H / IM2 EN / A31008-M2058-R201-2-SM19 / appendix.fm / 19.03.2009

Questions and answers

If you have any questions about using
your phone, visit us at
www.gigaset.com/customercare at any
time. The table below contains a list of
common problems and possible solutions.
Registration or connection problems with
a Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
guide for your headset).
¥
Delete registration data from the handset
when deregistering the device
¢
( page 39).
¥
Repeat the registration process
¢
( page 39).
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge the battery or replace it
¢
(
No Base flashes in the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
The range of the base is reduced because
eco mode is activated.
¥
Deactivate eco mode (
reduce the distance between the hand-
set and the base.
2. The base is not turned on.
¥
Check the base mains adapter.
Please register handset
"
play.
Handset has not yet been registered to the
base or has been de-registered.
¥
Register the handset (
Handset does not ring.
The ring tone is deactivated.
¥
Activate the ring tone (
The other party cannot hear you.
You have pressed the
The handset is "muted".
¥
Activate the microphone again
¢
( page 25).
page 8).
¢
page 34) or
" flashes in the dis-
¢
page 9).
¢
page 43).
display key.
§Mute§
You will hear an error tone when inputting
(descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activa-
ted or deactivated. As a pixel is made
up of three sub-pixels (red, green,
blue), it is possible that pixel colours
may vary.
This is completely normal and does not
indicate an error.

Authorisation

a
.
This device is intended for use within the
European Economic Area and Switzerland.
If used in other countries, it must first be
approved nationally in the country in
question.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs.
Bluetooth
The Bluetooth QD ID for your
Gigaset SL78H is: B013322.
Service (Customer Care)
ò
Qualified Design Identity
47