Table of Contents
Advertisement
Attaching the belt clip
The handset has notches on each side to accommodate the belt clip.
¤
Press the belt clip onto the back
of the handset so that the
notches on the belt clip click
into position.
Placing the handset in the base station and registering
Place handset
into base
Menu
Handset is
registering
ë
Ð
Þ
Menu
If you have purchased a model with multiple handsets, repeat the registra-
tion process for each handset. Handsets are assigned the lowest available inter-
nal number (1-4). If more than one handset is registered to the base station the
internal handset number appears on the display, e.g.
bers 1–4 are already assigned to other devices, the number 4 will be overwrit-
ten.
Before you can use the phone, you must
first register the handset to the base station.
¤
Place the handset with the display
facing up in the base station.
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
V
The following is displayed after successful
registration:
u
the strength of the reception signal
between base station and handset:
– good to poor: Ð i Ñ Ò
– no reception: | flashes
u
battery charge status:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging proce-
dure
INT
2. If the internal num-
First steps
11
Advertisement
Table of Contents
