Table of Contents
Advertisement
Connecting the phone to a
PABX
The following settings are only necessary
when your PABX requires them; see the
PABX user guide.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Dialling modes and recall
The current setting is indicated by
Changing the dialling mode
The following dialling modes can be
selected:
u
Touch tone dialling (DTMF)
u
Dial pulsing (DP)
M 4 O
§Menu§
~
Dial pulsing mode (DP).
§OK§
Or:
~ Q
Touch tone dialling (DTMF).
§OK§
a
Press and hold (idle status).
Setting recall
For operation on a PABX, you may have to
change this value. Please refer to the user
guide for your PABX.
M 4 O
2
§Menu§
~
Enter digits for the recall time
and press
0 = 80 ms; 1 = 100 ms; 2 = 120 ms;
3 = 180 ms; 4 = 250 ms; 5 = 300 ms;
6 = 600 ms; 7 = 800 ms
a
Press and hold (idle status).
‰
.
.
§OK§
Connecting the phone to a PABX
Setting pauses
Changing pause after line seizure
You can change the length of pause that is
inserted between pressing the talk key
c and sending the number.
M 4 O
O
§Menu§
~
Enter digit for the pause
length (1 = 1 sec.; 2 = 3 sec.;
3 = 7 sec) and press
a
Press and hold (idle status).
Changing the pause after the recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
M 4 O
4
§Menu§
~
Enter a digit for the length of
the pause (1 = 800 ms;
2 = 1600 ms; 3 = 3200 ms)
and press
a
Press and hold (idle status).
Switching temporarily to touch
tone dialling (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need touch tone dialling
(DTMF) for a connection (e.g. to listen to
the network mailbox) you must switch to
touch tone dialling for the call.
Precondition: You are conducting a call or
have already dialled an external number.
*
Press the star key.
After the call is ended, dial
pulsing is automatically acti-
vated again.
.
OK
§
§
.
OK
§
§
49
Advertisement
Table of Contents
