Quick Start - Raleigh ebike User Manual

1 Quick start

› 1. Charge the battery completely before riding for
the first time.
Unlocking the battery
› 2. To remove the battery, grip the handle, insert
the key into the lock and turn it anticlockwise. The
battery is now unlocked.
› 3. Tilt the battery sideways and lift it with both
hands out of the holder.
Tilt to remove
› 4. Put the battery in the docking station of the
charger. The battery LEDs light up or flash. You
must fully charge the battery before using it for the
first time.
› 5. Once all LEDs have gone out, take the battery
out of the docking station.
› 6. Reinsert the battery into the holder on the
Pedelec from the left-hand side. Move the battery
outwards at an angle of roughly 45° as you do so,
as you did when you took it out of the holder. Move
the battery into the upright position until the lock-
ing mechanism engages. If the key is still in the
lock, you will need to turn it clockwise and pull it
out to allow the battery to lock in place.
› 7. Make sure that the battery is securely posi-
tioned and that the key is no longer in the lock.
› 8. Push the "On / Off" button on the control panel
on the handlebar. Wait for 2 seconds before turn-
ing the pedals. The drive system requires this time
when no force is applied to the pedals to adjust the
power sensor correctly.
Press the "Assist" button to select the power assist
mode. This works in both directions. The assis-
tance output increases or decreases depending on
which "Assist" button you press. If you select the
most powerful setting then press the button again,
you return to a mode without assistance.
Always operate one of the brakes before putting one
of your feet on a pedal as the motor pulls your bike
away immediately. This starting assistance is very
convenient, especially when starting on hills. If you
start off in road traffic or on unsurfaced roads without
controlling your speed, you could come off your bike
and seriously injure yourself.
› 9. You can now ride off.
II User Manual Fast Pedelec 7