Table of Contents
Advertisement
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WASH PUMP MOTOR
Refer to page 4-16 for the procedure for servic-
ing the wash pump motor.
1.
Unplug dishwasher or disconnect power.
2.
Disconnect the wire connector from the
wash pump motor terminals.
3.
Set the ohmmeter to the R x 1 scale.
4.
Touch the ohmmeter test leads to indi-
cated wash pump motor terminals. The
meter should indicate as follows:
Terminal Number
1 & 2
2 & 3
1 & 3
WARNING
Electrical Shock Hazard
1 (R/W)
2 (Blu)
3 (Yel)
Reading
5 to 9 Ω
26 to 34 Ω
15 to 25 Ω
5-5
INLINE HEATER
Refer to page 4-16 for the procedure for servic-
ing the inline heater.
1.
Unplug dishwasher or disconnect power.
2.
Disconnect the wire connector from the
inline heater terminals.
3.
Set the ohmmeter to the R x 1 scale.
4.
Touch the ohmmeter test leads to the
inline heater terminals. The meter should
indicate between 14 and 16 Ω.
Terminals
Advertisement
Table of Contents
Troubleshooting
