KitchenAid briva KIDS01EK Technical Education page 43

9. Pull the fill spout and rinse agent dis-
penser assembly off the back of the dish-
washer and empty any of the liquid in the
dispenser into a container.
Dispenser Assembly
10. To remove the dispenser level switch:
a) Remove the rinse agent solenoid and
rubber seal from the dispenser tank
(see step 11 for the procedure).
b) Disconnect the wires from the switch
terminals.
c) Remove the rubber seals from the dis-
penser tank. Replace the seals if they
are cracked or torn.
NOTE: The switch and tank are re-
placed as an assembly.
Wire Connectors
Seals
Dispenser
Level Switch
11. To remove the rinse agent solenoid:
a) Remove the dispenser tank from the
housing and disconnect the wires from
the solenoid terminals.
b) Remove the mounting screw and re-
move the solenoid and rubber seal.
NOTE: Replace the rubber seal with
the solenoid.
Rinse Agent Solenoid
Wire Connectors
4-7
Rubber
Seal
T-15
Torx
Dispenser
Tank