Installation Information; Dishwasher; General - KitchenAid briva KIDS01EK Technical Education

In-sink dishwasher
Hide thumbs Also See for briva KIDS01EK:
Table of Contents

Advertisement

INSTALLATION INFORMATION

IMPORTANT: Observe all governing codes
and ordinances.
Proper installation is your responsibility:
• Contact a qualified installer.
• Installation must be performed by a qualified
service technician. The dishwasher must be
installed to all electrical and plumbing na-
tional and local codes and ordinances.
• Install the dishwasher as specified in these
instructions.
• Have everything you need to properly install

dishwasher.

Protect dishwasher and water lines leading
to dishwasher against freezing. Damage
from freezing is not covered by the war-
ranty.
The dishwasher is shipped ready for installa-
tion of a one-hole faucet. If a two-, three-, or
four-hole faucet is to be installed, the holes
must be added by a qualified plumber accord-
ing to the faucet manufacturer's specifications.
TOOLS AND MATERIAL REQUIRED
• Gloves
• Safety glasses
• 5/8" open-end wrench (for water fill line
connection)
• 3/8" deepwell socket (for undercounter
clamp brackets)
• 3/8" copper tubing with compression fitting
water fill line. The length needed is deter-
mined by specific installation require-
ments.
DISHWASHER

General

• Copper tubing with compression fittings
(for faucet connection). The length and
diameter needed are determined by spe-
cific faucet installation requirements.
• Small tubing cutter
• Faucet
• Two 1-1/2" drain traps
• 3-1/2" sink strainer
• Plumber's putty
• Sink strainer locknut wrench
• 10" adjustable wrench that opens to
1-1/8" (for 90° elbow)
• 90° elbow with 3/8" N.P.T. external
threads on one end (the other end must fit
your water supply line)
• Teflon™ tape, or pipe joint compound
• One cartridge of silicone caulk and a caulk
gun
If you are using direct wiring, you will need:
• Two twist-on connectors of the proper size to
connect the house wiring to the 16-gauge
dishwasher wiring
• U.L.-listed cable clamp or conduit connector
to fit a 7/8" inch hole
PARTS SUPPLIED
• Undercounter clamp brackets
• Cutting board
2-1

Advertisement

Table of Contents
loading

Table of Contents