Code Setting - Gliderol Glidermatic GRD Installation Instructions And Owner's Manual

I nstal lation Instructions
Transmitter Key and Code Setting
Refer to Fig. 9
Key Setting
Choose the Transmitter key configuration (lPIllP2llP3)
from the following :-
Single door installation (A)
K l r p z
|.-:_--l
-
l
J P 1
Code Setting
Once the Key configuration is set you can now program
in the security code from your hand transmitter (s)
o Press the learn code key once (8)
.
Learn LED Indicator will light (BA)
r
Press the hand transmitter Key that will operate the
door eg: for single door installation (A) you would
press Key 1
.
Learn LED (8A) will go out
.
The hand transmitter is now programmed
Multiple Hand Transmitters
Repeat the above instructions for any subsequent Hand
Transmitters.
The Control Module has enough memory for up to 10
individual Hand Transmitters.
lf more than 10 handsets are learnt the FIFO (First In First
Out) system applies ie first Hand transmitter code learnt
will be deleted and replaced by the last Hand Transmitter
code learnt.
Deleting Hand Transmitters From Memory
Press and hold the learn code key (8)* for 5 seconds.
All transmitter codes held in the memory have
- beellelase{.
Note: lf a transmitter is lost or stolen please erase the
memory and re-learn any spare or new transmttters.
Key Ring Transmitter
lnside of
Front
Cover
Back
Battery Type 12V (GP23A)
The battery should be replaced every 12 months
To reassemble:-
.
Hold front cover as per drawing
r
Insert membrane, then Printed Circuit Board (This will
locate as per drawing)
r
Insert 12Volt Battery (GP23A) Positive towards screw
c Locate back of case and screw together
The above jumper configuration will allow
hand transmitter to be programmed.
Note: The jumpers are located on the
Printed Circuit Board. (JP1,JP2,JP3).
Single door installation (B)
F.=l
I S Y J
t;ffi
I
'\--ll
D;ffi
l'a:-:,1
Key 1 on the
Control Box
J P 1
JP2
J P 3
This above configuration uses all three keys.
.1'. Up
Key 2
I Stop Key 1
rf
Down Key 3
Two or Three door installation
C/Box 1
C/Box 2
OBox 3
t e o - l @ l I o o o l
r p r
@ l t t o d l
l o o o l r p z
t-EFo;lG-d{
rn:
Door 1
Jumper configuration for transmitter Key
'l
only
Door 2
Jumper configuration for transmitter Key 2 only
Door 3
Jumper configuration for transmitter Key 3 only
PCB
Key 1
GRD OWNERS MANUAL PAGE 5
@.c^t-l?'E't8-