Gliderol Glidermatic GTS+ Quick Start Manual

Glidermatic GTS+
Handset Key Settings
The following instructions demonstrate how to program or change the key settings on your Gliderol
handset, allowing you to select the specific button that operates your door. This procedure will assist
in reprogramming your handset from three-button Open/Stop/Close operation to single-button
operation. It will also assist in reprogramming your handset to operate multiple doors.
Step 1:
ENTER
BUTTON
Press and hold the 'Enter' button (shown above)
for 2 seconds to access the operator menu. The
unit will beep twice to confirm this has been
selected.
Note: Pressing the enter button for 5 seconds or more will
erase all handset data from your operator - be careful not to
press the enter key for longer than neccessary.

Step 3: Single Button Operation (1-3 doors)

2
KEY
The display bar will illuminate as per the above image to show the current key settings. Using the arrow
(Up & Down) buttons, select the desired button to operate your door. Press 'Enter' to confirm your
selection. The unit will beep once to confirm your key settings have been saved and your setup was
successful.
Note: Changing the key setting on your operator will update all programmed handsets.
1
KEY
3
KEY
KEY 1
Step 2:
ENTER
BUTTON
Use the arrow (Up & Down) buttons to select
the 'Key' option and press 'Enter' to confim
selection.
KEY 2
www.gliderol.com.au
KEY
OPTION
KEY 3