Opener Accessories Programming; Enable Optional Photo Sensor Beams; Enable Optional Auto-Close Setting - Gliderol GENESIS Installation & User Manual

5.0 Opener Accessories Programming

5.1 Enable Optional Photo Sensor Beams

Optional Photo Sensor Beams are available to prevent a door from closing when an obstruction
(person, object etc) is located in the beams path. By default, Photo Sensor Beams are disabled
(setting 'H0') on all units. To enable this feature please complete the following steps:
Item
5.1.1 Press 'SET' until 'P1' is visible on the display.
5.1.2 Press the 'UP' button twice and 'P3' will be visible on the display. Press 'SET'
to confirm selection.
5.1.3 To enable functionality, press the 'UP' button once and 'H1' will be visible
on the display.
5.1.4 Press the 'SET' button to save selection in the units memory.
To disable, complete steps 5.1 and 5.2 then press the 'DOWN' button and 'H0' will be visible on the
display. Press the 'SET' button to save selection in the units memory.
Note: If Photo Sensor Beams are not connected, please ensure 'H0' is selected otherwise the door
will not close and the control panel will display

5.2 Enable Optional Auto-Close Setting

Please note this feature is only available for doors fitted with optional Photo Sensor Beams. The Auto
Close feature only activates once the door reaches the open position.
By default, Auto-Close is disabled (setting 'b0') on all units. To enable this feature please complete
the following steps:
Item
5.2.1 Press 'SET' until 'P1' is visible on the display.
5.2.2 Press the 'UP' button three and 'P4' will be visible on the display. Press 'SET'
to confirm selection.
5.2.3 Using the reference table below as a guide, use the 'UP' and 'DOWN'
buttons to select your preferred Auto-Close setting.
5.2.4 Press the 'SET' button to save selection in the units memory.
Setting Code
Time (sec)
Description
Description
b0 b1 b2
0 10 20
b3 b4 b5
30 40 50
Display
(
example)
Display
(
example)
b6 b7 b8
60 90 120
b9
180
11