Gliderol Glidermatic G+ Programming

Glidermatic G+ Control Box

Programming New Handsets

The following instructions demonstrate how to program a new or additional Gliderol handset to your
existing Glidermatic G+ Control Box. Please note, if you are replacing a lost or stolen handset we
recommend erasing all existing handset data from your operator prior to programming your new
handset. Please refer to your Glidermatic G+ Control Box Owners Manual for further information on this
process.
Depending on the age of your unit, your 'learn' button will be located in one of the two
positions shown. For units installed prior to July 2017, refer 'Postion One' instructions.
For units installed after this date, refer 'Postion Two' instructions.

Step 1:

COVER
TAB
Carefully remove the light cover by pulling down
on the tab near the front of the unit.

Step 2 (Position Two):

Press the 'Learn' button once. A red light will
illuminate and the control box will beep three
times to confirm the unit is in learn mode.

IMPORTANT - READ BEFORE PROCEEDING

LEARN
OPTION

Step 2 (Position One):

Press the 'Learn' button once. A red light will
illuminate and the control box will beep three
times to confirm the unit is in learn mode.

Step 3:

Press the Main/Key 1 button on the handset.
The unit will beep once to confirm successful
coding.
www.gliderol.com.au
LEARN
OPTION
MAIN KEY/
KEY 1