VIVOTEK
Set up the Network Camera through Power over Ethernet (PoE) (FD8134V only)
When using a PoE-enabled switch
The Network Camera is PoE-compliant, allowing transmission of power and data via a single
Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled
switch via Ethernet cable.
power + data transmission
PoE Switch
When using a non-PoE switch
If your switch/router does not support PoE, use a PoE power injector (optional) to connect
between the Network Camera and a non-PoE switch.
Po E Po w e r In j e c t o r
( o p t i o n a l )
No n - P o E Sw i t c h
User's Manual - 9