Run The Pingme.c Demo - Z-World Wolf BL2600 User Manual

5.2.3 Run the PINGME.C Demo

Connect the crossover cable from your computer's Ethernet port to the BL2600's RJ-45
Ethernet connector. Open this sample program from the
compile the program, and start it running under Dynamic C. When the program starts run-
ning, the green LNK
is made. (Note: If the
you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the ping program:
ping 10.10.6.100
or by >
Start Run
and typing the command
ping 10.10.6.100
Notice that the orange
indicates the transfer of data. The ping routine will ping the board four times and write a
summary message on the screen describing the operation.
User's Manual
light on the BL2600 should be on to indicate an Ethernet connection
LNK light does not light, you may not have a crossover cable, or if
light flashes on the BL2600 while the ping is taking place, and
ACT
SAMPLES\TCPIP\ICMP
folder,
67