void digOut(int channel, int state);
Sets the state of a configurable I/O channel (DIO00–DIO15) configured as a sinking digital output to a
logic 0 or a logic 1. This function only allows control of channels that are configured to be an output by
the digOutConfig function.
Remember to call the brdInit and the digOutConfig functions before executing this function.
A runtime error will occur for the following conditions:
1. channel or state out of range.
2. brdInit or digOutConfig was not executed before executing digOut.
3. If you try to use a channel that is not configured as a digital output by digOutConfig.
PARAMETERS
channel is the output channel number (0–15).
state sets a given channel to one of the following output states.
0 = connect the load to GND
1 = put the output in a high-impedance state
RETURN VALUE
None.
SEE ALSO
brdInit, digHout, digOutConfig, digBankOut, digIn
46
Wolf (BL2600)