Run The Pingme.c Sample Program - Z-World Wildcat BL2000 User Manual

5.3 Run the PINGME.C Sample Program

Connect the crossover cable from your computer's Ethernet port to the BL2000's RJ-45
Ethernet connector. Open this sample program from the
compile the program, and start it running under Dynamic C. When the program starts run-
ning, the green
LNK
is made. (Note: If the
you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the pingme program:
ping 10.10.6.100
or by
Start > Run
and typing the entry
ping 10.10.6.100
Notice that the orange
indicates the transfer of data. The ping routine will ping the board four times and write a
summary message on the screen describing the operation.
User's Manual
light on the BL2000 should be on to indicate an Ethernet connection
light does not light, you may not have a crossover cable, or if
LNK
ACT light flashes on the BL2000 while the ping is taking place, and
SAMPLES\TCPIP\ICMP
folder,
55