Z-World Wolf BL2600 User Manual page 80

Header Description
JP2 DIO08–DIO15
JP3 DIN16–DIN19
JP4 DIN20–DIN23
JP5 DIN24–DIN31
A/D Converter Voltage/Current
JP6
Measurement Options
RS-485 Bias and Termination
JP7
Resistors
* Although pins 1–3 and 4–6 of header JP7 are shown "jumpered" for the termination and
bias resistors not connected, pins 3 and 4 are not actually connected to anything, and this
configuration is a "parking" configuration for the jumpers so that they will be readily avail-
able should you need to enable the termination and bias resistors in the future.
76
Table A-2. BL2600 Jumper Configurations
1–2
3–4
5–6
7–8
1–2
3–4
5–6
7–8
1–2
3–4
5–6
7–8
1–2
3–4
5–6
7–8
None Voltage Option
1–2 AIN0 4–20 mA option
3–4 AIN1 4–20 mA option
5–6 AIN2 4–20 mA option
7–8 AIN3 4–20 mA option
1–2
5–6
1–3
4–6
Pins Connected
Inputs pulled up to +5 V
Inputs pulled up to DCIN
Inputs pulled up to +K
Inputs pulled down to GND
Inputs pulled up to +5 V
Inputs pulled up to DCIN
Inputs pulled up to +K
Inputs pulled down to GND
Inputs pulled up to +5 V
Inputs pulled up to DCIN
Inputs pulled up to +K
Inputs pulled down to GND
(needed for these to be PWM outputs)
Inputs pulled up to +5 V
Inputs pulled up to DCIN
Inputs pulled up to +K
Inputs pulled down to GND
Bias and termination resistors
connected
Bias and termination resistors not
*
connected
Factory
Default
×
×
×
×
×
×
Wolf (BL2600)