Z-World Wolf BL2600 User Manual page 68

The PC running Dynamic C through the serial programming port on the BL2600 does not
need to be the PC with the Ethernet card.
3. Apply Power
Plug in the AC adapter. The BL2600 is now ready to be used.
NOTE: A hardware RESET is accomplished by unplugging the AC adapter, then plug-
ging it back in, or by momentarily grounding the board reset input at pin 9 on screw ter-
minal header J2.
When working with the BL2600, the green
the board is properly connected either to an Ethernet hub or to an active Ethernet card. The
orange light flashes each time a packet is received.
ACT
64
light is on when a program is running and
LNK
Wolf (BL2600)