Teaching Other Pre Commands - PROCEED PRE User Manual

Teaching Other
PRE Commands
36
Press and hold the corresponding button on the PRE for about
5
3 seconds. The LCD on the PRE remote will show – – – –
indicating that it is receiving the information from the original
remote control.
Release the button on the PRE. The LCD on the PRE remote
6
will show RETRY
Press and hold the same button on the PRE once again, for
7
about three seconds. The LCD on the PRE remote will flash
, the
GOOD Device Mode
that the new function has been learned.
Repeat Steps 4 through 7 for any other buttons you wish to re-learn from the
front panel of the PRE.
Once you have completed the learning for all the desired but-
8
tons, store the learned functions by pressing the device and
play buttons simultaneously, once again. The LCD in the PRE
remote will show
The remote has now returned to the original operating mode.
Once you have stored the learned functions, test the buttons that have been
taught. If any of the buttons do not operate as they should, please repeat from
Step 1 for those buttons.
If the LCD shows
NOTE: FAIL
remote was unable to learn the new functions. Please repeat from Step 4.
When finished, exit the programming mode of the PRE by press-
9
ing and holding the
also wait for the PRE to "time out" and return to normal operation.
Alternatively , you may wish to continue on to the next section to
teach your remote control the PRE' s special commands, in which
case you should go directly to step #2.
As mentioned above, the PRE has the capability to teach its own (or other)
learning remote controls special commands for which there are no front-
panel counterparts. These include the commands that toggles the PRE
between stereo/mono , normal/inverted polarity
In addition, there are several "hard assignment" commands available in the PRE
which will place it into a certain mode of operation regardless of its current state.
For example, a hard assignment command to enter
if already there, or switch it to
standby
type of hard assignment command is especially helpful when you do not neces-
sarily know the current status of the PRE, as might be the case in a multi-room
home entertainment system (for example).
.
and then return to
SAVED and then return to the
at any time during the learning process, the PRE
button again. Y ou could, of course,
balance
, and
standby
if it is currently operating. This
standby
, verifying
LEARN
Device Mode .
display on/off modes.
will leave the PRE in