Programming Memory Buttons - PROCEED PRE User Manual

To program the Memory Buttons, follow these steps:
programming
memory buttons
NOTE:
during Memory button programming.
NOTE:
command sequence.
IMPORTANT NOTE:
sequence of macros entered will clear and you will need to start over.
NOTE:
button. Please continue to point the remote control at the device(s) until all the
commands on the Memory Button have been sent out. This will ensure that all
the commands are received by the device(s).
Example:
power
appears in the LCD. Next, press the
for the PRE. Press
again, to select TV Power. Finally, press
select Cable power. Press the
After following these steps, each time you press the power/standby button,
after either the sat, tv , vcr or cbl Device control selector has been pressed, the
remote will send the "Power On/Off" command.
Select the section that you wish to program the Memory But-
1
ton in by pressing the corresponding Device button (
) and mute button, simultaneously.
sat
LCD.
Press one of the Memory Buttons (
2
) into which you wish to store the functions.
standby
5)_## will appear in the LCD.
The button is used to designate POWER/STANDBY commands
mute
3 Press in up to fifteen commands that you want stored in that
Memory button. Each successive button selection will appear
as in the LCD.
M(1-5)_(01-15)
Y ou can select functions from another mode by first pressing
the corresponding Device button and then the buttons where
those functions are located in that mode. The pressing of a
Device button also counts as one command.
Each insertion of a Device Button adds a 1/2-second delay to the
Press the
4 channel +
flash three times in the LCD to confirm the programming.
If you attempt to store more than 15 commands, the entire
It can take up to 15 seconds to send out 15 commands from a memory
To program your TV, Cable Box and the PRE to turn on when the
button is pressed, first press-and-hold the sat and mute buttons until
tv to select the TV mode, and then press the
channel +
will appear in the
SET
, ,
m1 m2 m3
button to store your selections.
button to enter the Power commands
mute
cbl followed by the
button to enter the commands.
or
audio
, or
m4 power/
M(1-
will
SAVE
SET
mute button
mute button to
33